The Best Crossword Puzzle Maker Online
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crossword Word Search Worksheet
Rate This Puzzle:
Log in or sign up to rate this puzzle.

Das 125 Q2 ch 45

Across
Type I glass ionomer cement is used for _______________ cementation.
Zinc phosphate cement cotains phosphoric _____________ and is irritating to the pulp.
ZOE cements are used for direct _______________restorations and will need to be removed in a short period of time.
Loss is minimized when power is dispensed before the liquid.
If excess cement is not removed from in and around the cavosurface margin, the cement can irritate the area and cause ______________and discomfort.
______________Cement is less irritating to the pulp than zinc phospate cement.
Type I _________ is frequently used for cementing provisional coverage.
It is important to mix the_____________by manufacturer's instructions.
Dispense the powder first and then the ______________.
Dentin Should not be dried completely to avoid ______________.
Properly mixed glass ionomer cement should have a ______________appearance.
Zinc phosphate should be mixed ____________ to help dissipate heat.
A_____________between completion of the mix and seating for final cementation will result in an initial setting process, and casting may not seat completely.
Glass ionomer cement powder contains_____________, which is slowly released and assists in inhibiting recurrent decay.
Down
Zinc____________cement gives off an exothermic reaction and must be spatulated over a wide area of a coll, dry, thick glass slab to dissipate the heat.
To increase the working time of glass ______________, it can be mixed on a glass slab
Because Zinc phosphate is irritating to the pulp, if used as a base it requires the use of a ______________.
_______________cement is starting to set if it appears stringy or weblike.
Composite resin cement has been designed especially for ______________ of ceramic or porcelain inlays & onlays, crowns & bridges, and ceramic veneers.
When dispensing, most cement power should be _______________ and measured, but not packed before dispensing.
______________temperature, and mixing time are all factors that can influence the cementation procedures.
Type 1 ______________cements are used to retain permanent indirect restorations.
Having a tooth free of debris is a requirement of composite ______________cement.
To_____________the heat from polycarboxylate before cementation on a prepared tooth, the cement must be spatulated over a cool, dry, thick glass slab.
_____________excess cement down away from casting will stretch or weaken the material under the margins.